Propylene Pleasure Palace -

IMotion V3

Imotion V3 Pure Class
Variable Voltage Variable Wattage Kit

More details

On sale On sale!


9 items in stock

For Expierenced Users

I Motion V3 VV-Vw Pure Class Full Kit


1 Imotion V3 Device

1 Imotion rebuildable Tank

1 18650 Battery

1 18650 Charger

1 Gift Box



1-Variable Voltage: 3.0~6.0v

2-Variable Watts: 3W-10W

3- Ultra low static current

4- Built-in three digital LED screen

5- Adjustable positive pin in center of the thread, can fix the poor connection problem

6- Preserved previous settings once you change the battery or take off the battery

7- Amperage limiting system protects against over current situations

8- Reverse battery protection keeps circuit safe if the batter is installed backward

9-Single 1500MAh high drain battery

2 Month Limited Warranty, does not cover abuse, cosmetics, water damage, etc. 


Assembly the battery and Cartomizer/atomizer with smoke juice correctly. Standby is started after the device is not working within 5 seconds

1 Power switch:
Press the centre button(red button) above 3s, it will be Power on/off. When the power is off, the device will stop working. When it is ON, press the centre button, it will show battery voltage, for example, 3.7V will display “3.7U”

2 Lock protection:
Press "-" and "+" button at the same time above 3 seconds, the setting will be locked or unlocked.

3. Resistance,Voltage and Wattage Setting Instructions:
Press the big button 5 times to start the setting choice mode, then press the button "-" or "+" to choose the setting mode: "1.dR"-Display resistance, "2.dU"-Display Voltage,"3.dP"- Display wattage. After that press the big button or leave button 1.5s to confirm the choice.
3.1 Under the "1.dR"mode, press the big button again, the display shall show the resistance of the Cartomizer/atomizer, for example, 4.0? will display “4.0o”. if without Cartomizer/atomizer, it will show F1.
3.2 Under the "2.dU"mode, press the "-" or "+" button to adjust voltage up or down in a circle of 3V~6V,with 0.1 volt increments, for example, 3.7V will display “3.7U”. then press the big button again or wait for 3s, the display is off, your setting is preserved.
3.3 Under the "3.dP"mode, press the "-" or "+" button to increase or decrease of the wattage in a circle of 3P~10P,with 1watt increments, for example, 9W will display “9.0P”then press the big button again or wait for 3s, the display is off, your setting is preserved


Imotion Rebulidable Tank


1 Unscrew the cap and oil sealing cylinder.

2 Drop e liquid through the hole.

3 Screw on the cylinder

4 The upper cap when oil filling completed.


Change heating coil

1 Unscrew terminal screws

2 Take out heating components

3 Change new heating coil, note string pointing at the hole.

No customer comments for the moment.

Only registered users can post a new comment.


No products

Shipping $0.00
Total $0.00

Cart Check out

New products

No new products at this time